![]() ![]() But, they will tell you what they can do when you go to them will a well reasoned set of plans. This is really not something that lends itself well to a simple, industry wide rule-of-thumb, the entire process is just too dependent upon the equipment and methods used and individual experience, so that info. We always routed the raw materials directly from the steel mills to our sub’s plant they did the rough cutting and bending, etc. Some of these subs are better at handling one type of shape than another. ![]() ![]() This type of bending work is quite a specialty in terms of the needed equipment, knowledge and experience, and what they can actually achieve with a given shape and size, without bending/buckling the hell out of the whole section. You will also see ads for this type of work in various structural steel mags. Make a second bend mark four inches from the vertex of the 90 degree bend, away from the reference mark. Bend the tube 90 degrees as described in the tech tip video. Ask them who they would job this bending work out to (sub this bending out to), and then talk with those people who specialize in this large structural shape and HSS bending. Measure four inches from the reference mark and make a bend mark to indicate the first desired bend length. I would talk with several structural steel fabricators who you have worked with in the past or who might be involved in this project.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |